
- Home
- >
- News
- >
- Industry news
- >
News
Heating efficiency is one of the most important factors that users are concerned about when heating a hot tub. When the jet is running, it can indeed help to distribute heat more evenly in the water by accelerating the water flow and promoting water agitation.
A hot tub without a cover will lose a lot of heat, and the heating system will have to start more frequently to maintain the water temperature. Even if the cover is not used for only a short interval, the heat loss is still significant. For those who want to save money on their electricity bills, always using a hot tub cover is a simple and effective energy saving measure.
First check the capacity label of the main circuit breaker on the distribution board. It is usually marked with "100A", "150A" or "200A", indicating the maximum current that the distribution board can handle. If your home's power needs (including your outdoor massage bathtub) are close to or exceed this number, you may need to upgrade your electrical panel.
Generally speaking, the larger the capacity of a swim spa, the longer it takes to complete a water circulation. For example, a 1500 liter swim spa may take 2-4 hours to circulate, while a larger device, such as a swim spa with an 8000 liter water capacity, may take 6 hours or even longer to complete a cycle.
Generally speaking, the temperature range of a hydromassage bathtub should be controlled between 37°C and 40°C, which is the most comfortable temperature for the human body and has ideal health benefits. It is recommended that the bathing time in warm water around 40°C should not exceed 15-20 minutes.
Since the hot tub heater is directly involved in the heating and circulation of water, it inevitably involves the water in the bathtub when replacing the heater. The replacement operation of the hot bathtub heater requires disconnecting the water pump and the pipe system, which usually means that the water needs to be drained to prevent water from overflowing or leaking during the operation.
The low temperature environment in winter poses many challenges to the operation of outdoor hot tubs, the most obvious of which is the rapid loss of water temperature and the potential risk of equipment damage. Therefore, covering the hot tub has become a key measure to protect the equipment and save energy.
Even if you need to have hydro massage frequently, make sure you have enough rest time between each massage. It is recommended to have a maximum of one hydro massage per day, with at least 24 hours between each massage. This allows the body enough time to recover and avoids overstimulating muscles and joints.
After adjusting the outdoor hot tub alkalinity, users need to give the water quality a certain amount of time to stabilize. Generally, you should wait at least 4 to 6 hours after adjusting the hot tub alkalinity before adjusting the pH. This is because when adding chemicals to adjust the alkalinity, the chemical reaction in the water takes a certain amount of time to complete.
The growth of algae is often accompanied by changes in the chemical composition of the hot tub water, such as increased hot bathtub pH and turbidity. Contact with water containing algae may cause discomfort to the eyes and respiratory tract, especially when other harmful microorganisms are present in the water.
The bathtub's filtration system will work for 30 minutes to 1 hour during the impact process to ensure that the water quality meets the hygienic standards. However, the length of the filtration time also depends on the chemical agents used, the type of disinfection system (such as ozone disinfection, ultraviolet disinfection, etc.) and the degree of water pollution.
Compared with traditional swimming pools, the water flow system of swim spa is more complicated, requiring precise water pumps, pipes and jet systems to ensure smooth water flow and sufficient pressure. The installation of these systems often involves the use of pipes.